Introduction:
An article showing the location of the main gas valve on the Dr. Oligo 192c and how it is connected to the Biolytic board.
Applies to:
This document applies to the following.
Part Number | Description |
403-107733 | Dr. Oligo 192-C Plate Oligo Synthesizer Instrument |
615-107775 | Main Gas Valve Pneumatic Assembly |
181-108033 | Biolytic Board |
Procedure:
- Looking at the back of the instrument, the Left Panel is on the right-hand side of the instrument. There you will find several important valves, including the Main Gas Valve.
- The Main Gas Valve will be near the bottom of the Left Panel, close to the regulator. On the valve there should be a wire connector. Make sure that the connector is securely attached to the valve and that the wires are secure in the connector.
- The wire from the Main Gas Valve then goes to the Biolytic Board 1.
- The Main Gas Valve wiring should connect to Channel 1 which is in the back of the row on the right side of the board. Make sure the connection is secure and that the wires are securely in the connector.